SY5120-5DZ-C6F-Q，进口SMC先导式电磁阀[产品打印页面]

SY5120-5DZ-C6F-Q，进口SMC先导式电磁阀
注1）•工作压力为20℃时的值对于其他温度下，从爆破压力计算
此外，温度异常上升，由于绝热压缩可能会导致油管burst.To操作
温度低于20℃外，工作压力不得超过使用下面的公式计算出的值更多：
材料和流体相容性检查清单提供的参考值仅供参考。
注1）由于可能会产生静电，实施适当的对策。
•兼容性的适应症为200℃或更低温度的流体。
•材料和流体相容性检查清单提供的参考值
只是一个指南，因此我们不保证应用到我们的产品。
•以上数据是根据材料商提供的信息。
5. Countermeasures for static electricity
Since static electricity may be generated depending on the fluid
being used, implement suitable countermeasures.
1. After mounting, perform suitable function and leak
tests to confirm that the mounting is correct.
Mount and operate the product after reading the manual carefully
and understanding its contents. Also keep the manual
where it can be referred to as necessary.
3. Use sealant tape for the piping of taper thread parts
•SMC不负责其准确性以及任何损害发生这个数据，因为。
当值（使用下面的公式计算）超过1 MPa时，。操作压力为1MPa。
（工作压力）=1/4×（爆破压力降系数）×（20℃爆破压力）
•当使用液体形式的流体，浪涌压力必须不超过工作压力更多。
浪涌压力大于工作压力高可引起管子的接头或破裂的破损。
注2）小弯曲半径是使用在右图所示的方法测定。
注3）它是连接与LQ系列（3/4“尺
至于其他的商业项目，也有一些情况下是无法连接
Refer to the pamphlet 揌igh-Purity Fluoropolymer Fittings HYPER
FITTING?Series LQ1, 2 Work Procedure
(M-E05-1) for connecting tubing and special tools. (Downloadable
Note) Body class 1 must be tightened manually.
Give careful consideration to operating conditions such as the
application, fluid and environment, and use within the operating
ranges specified in this catalog.
Operate within the indicated fluid temperature range.
Ensure the necessary space for maintenance and inspections.
Keep the supplied fluid pressure within the operating pressure
such as LQ1H and LQ1L.
Tape the ridges tightly with the sealant tape, starting one ridge
width left from thread end side. 3 to 4 sealant tapes are required.
 

产品留言

标题

联系人

联系电话

内容

验证码

点击换一张

注：1.可以使用快捷键Alt+S或Ctrl+Enter发送信息!
2.如有必要,请您留下您的详细联系方式!